The remote control
Insert the battery
1 Push the catch in the direction shown by arrow ① to remove the holder.
2 Insert the battery with the “+” marked side facing up.
3 Return the holder to its original position.
•When the battery (CR2025) has run out, replace it with a new one. (The battery lasts about one year, depending on the frequency of use.)
If the remote control unit fails to work even when it is operated near the
•Keep the battery out of the reach of children.
Remote control usable range
The distance between the remote control and the unit’s remote control sensor: Within approx. 5 m Angle: Approximately 15° upward,
approximately 10° downward, approximately 15° leftward, or approximately 15° rightward (Except when optional accessories are attached)
Remote control sensor
•The remote control is intended for indoor operation. Outdoors or under strong light, the unit may not operate properly even within the usable ranges.
Turn on/off the camera
While pressing the lock release button, move the POWER switch to ON or OFF.
Turn on the camera:
The mode lamp (CAMERA) lights red (camera mode), and the camera enters recording standby mode.
Turn off the camera:
The mode lamp (CAMERA) goes out.
QUICKSTART | |
CAMERA |
|
PB |
|
PHOTO | POWER |
| |
•
According to the settings made in the POWER SAVE item of the OTHER FUNCTIONS screen
in the settings menu, the following will apply if no designated operations∗ are performed for approximately five minutes in recording standby mode (when an SD Memory Card has been inserted while using the battery).
ON: The camera recorder turns off automatically.
OFF: Does not switch OFF the camera.
∗See the setup menus, POWER SAVE (Page 110) for details.
Mode lamp
QUICKSTART
| CAMERA |
|
| PB |
|
| PHOTO | POWER |
| NMODE | |
FO |
| |
F |
|
|
O |
|
|
POWER switch
Set the POWER switch to the ON position while pressing the lock release button.
The CAMERA lamp lights (red), and the camera enters recording standby mode.
Lock release button
26