Viewfinder (continued)

Using the LCD

Emphasizing outlines

1 Set the POWER switch to ON. (Page 26)

2 Open the LCD monitor.

The monitor opens up to 90°. Attempting to open it further with force may damage the camera.

90°

3 Adjust the angle of the LCD monitor to a convenient viewing position.

•The monitor can be rotated 180° toward the lens and 90° toward the eye piece.

•Attempting to rotate it further with force or closing it in a 90° position may damage the camera.

180°

90°

•When closing the LCD monitor, be sure to close it fully.

•When the LCD monitor is facing the lens (during self-portrait recording), both the viewfinder and the LCD monitor will be lit.

When EVF DTL is assigned to one of the USER buttons 1 to 3, you can press that button to emphasize the outlines of images in the viewfinder or LCD monitor, and make focus alignment easier. Emphasizing the outlines does not effect the images you shoot.

1 Touch USER1 SW, USER2 SW, or USER3 SW in the setting menu SW&DISP SETUP screen.

2 Touch EVF DTL.

EVF DTL is assigned to the selected USER button.

3 In CAMERA mode or PHOTO mode, press the USER button assigned to EVF DTL. “EVF DTL ON” appears in the center of the screen for about 2 seconds.

To release the setting, press the USER button assigned to EVF DTL again, and “EVF DTL OFF” appears in the center of the screen for approximately 2 seconds.

30