Quick Start mode
This mode allows you to begin recording more quickly. When using Quick Start mode, you can begin recording approximately 1.5 seconds after Quick Start standby mode.
■Setting
Hold down the QUICK START button for at least two seconds while the power is on. The camera will enter Quick Start standby mode and the CAMERA and PHOTO lamps will flash.
ヲヶリヱヤモヮユンャレチヴヰヱヸユンヵモンヵ ラ
QUICK START button
■To start recording
When the QUICK START button is pressed in the Quick Start standby mode (lamps flashing), the lamps light and the camera enters recording standby mode.
•Quick Start mode will be canceled in the following cases.
�The camera remains in Quick Start standby mode for more than 30 minutes
�Battery is low
�Battery has been removed
�POWER switch is set to OFF
•Quick Start standby mode consumes power, resulting in reduced total recording time.
•Depending on recording settings, Quick Start may take longer than 1.5 seconds.
•Automatic white balance adjustment may take longer in Quick Start mode.
•The zoom ratio will be set to approximately x 1 wide end (Z00) with Quick Start.
Preparation
Tally lamp
You can set the tally lamp to light in the following | Tally lamp | |
situations by setting the REC LAMP item (Page | ||
|
109)in the OTHER FUNCTIONS screen to ON.
• Battery is low (flashes 4 times per second)
• Available SD Memory Card capacity is low (flashes 4 times per second)
• Remaining battery capacity is low (flashes once per second)
• Remaining memory of the SD Memory Card is low (flashes once per second)
In addition, the tally lamp will flash regardless of the REC LAMP setting when receiving commands from the remote control.
27