Panasonic AJ-D950 manual Displaying the Hours Meter information

Displaying the “HOURS METER” information

Turn the search dial to move the cursor ( * ). The description for the item where the cursor is located is shown on the counter display.

Item No.	Item	Description
H00	OPERATION	Displays the time that the power has been supplied in one-hour units.
H01	DRUM RUN	Displays the time that the drum has been rotating in one-hour units.
H02	TAPE RUN	Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
		VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in
		one-hour units.
H03	THREADING	The number of times for threading/unthreading is displayed in single units.
H11	DRUM RUN r	Displays the time that the drum has been rotating in one-hour units. (Can be reset)
H12	TAPE RUN r	Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
		VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in
		one-hour units. (Can be reset)
H13	THREADING r	The number of times for threading/unthreading is displayed in single units. (Can be reset)
H30	POWER ON	The number of times the power has been turned on is displayed in single units.

<Notes>

•The resettable items in the “HOURS METER” information are reset by the shop when performing maintenance or other work.

•The search buttons and the search dial cannot be operated while the DIAG menu is displayed.

If “T&S&M” is selected in the setup menu No. 008 (DISPLAY SEL), a message appears in the mode display whenever a warning or error occurs. When multiple events occur, the event with the highest priority is displayed.

Priority	Display	Description
High	Error messages	When an abnormal operation is detected in this unit, the AUTO OFF lamp lights up
	(See error message table)	and an error message is displayed.
	INT SG	If “BB” or “CB” in No. 600 (INT SG) in the setup menu is selected, pressing the REC
		button or the EDIT button (E to E mode) will display “INT SG” for the first two
		seconds. This is also displayed for the first two seconds when starting editing.
	NO INPUT	If there is no input signal (except for analog audio) to the connector selected using
		the INPUT SELECT switch, pressing the REC button or the EDIT button (E to E
		mode) will display “NO INPUT” for the first two seconds. This is also displayed for
		the first two seconds when starting editing.
	Warning messages	When a warning occurs in this unit, the warning lamp lights up and a warning
	(See error message table)	message is displayed. When multiple warnings occur, the warning with the highest
Low		priority is displayed.

Warning messages

Priority	Monitor display	Description	VTR operation
High	FAN STOP	This is displayed when the fan motor stops.	Operation continues
	SERVO NOT LOCKED	This is displayed when the servo is not locked for three or	Operation continues
		more seconds during playback, recording, or editing.
	LOW RF	This is displayed when envelope levels approximately 1/3
		that of normal levels are detected for more than one second	Operation continues
		during playback, recording, or editing.
	HIGH ERROR RATE	This is displayed when the error rate increases and
		correction/interpolation is performed on either the video or	Operation continues
Low		audio playback signal.

– 73 –