P2Store Manager screens (continued)

Setup pageFor checking and changing the unit's operating parameters.
High temperature mode section

You can specify whether HDD operation is suspended or remains active if the internal HDD temperature exceeds a prescribed level.

Options: [Suspend] and [Active]. Default: [Suspend].

The unit’s current setting is displayed in the “Current Setting” section.

If you change it, afterward click the [Apply] button .

Note:

Setting to [Active] may result in failure of the HDD.

Use this setting at your own risk.

Under Limit of HDD access section

You can specify the minimum ambient temperature at which HDD operation is permitted.

Options: [5 deg / 41 F] and [-5 deg / 23 F].

Default: [5 deg / 41 F].

The unit’s current setting is displayed in the

“Current Setting” section. If you change it,

afterward click the [Apply] button .

Note:

Setting to [-5 deg / 23 F] may result in failure of the HDD.

Use this setting at your own risk.

Shock detection in USB mode section

Use [ON] and [OFF] to enable or disable impact detection when the unit is connected to a computer via the USB 2.0 cable.

[ON] (default):

Data transfer with the computer is suspended if the unit is hit.

[OFF]:

Data transfer is maintained even if the unit is hit.

The unit’s current setting is displayed in the “Current Setting” section.

If you change it, afterward click the [Apply] button .

Note:

The possibility of HDD failure is higher with the [OFF] setting than with the [ON] setting. Use this setting at your own risk.

Auto power off mode section

You can specify the time until the unit switches OFF automatically if left unused (when no copying or formatting is in progress).

Options: [Never], [5 min], [10 min], [15 min], [20 min], [25 min], and [30 min].

Default: [10 min].

The unit’s current setting is displayed in the “Current Setting” section.

If you change it, afterward click the [Apply]

button . Note that auto power OFF is disabled when the unit is connected to a computer.

Initialize button

You can restore the default settings in sections

, , and . However, note that the setup details are not applied automatically.

If you change them, click the [Apply] button .

Apply button

You can save the setup details in sections ,

, and on the unit as follows. 1. Click the [Apply] button

A confirmation dialog is displayed.

2. Click [Yes]

The setup details are saved on the unit.

3.Restart the unit.

Note:

ENGLISH

The new setup takes effect after the unit is restarted.

E-26