Panasonic AK-HCU200ES Iincom switches 1, 4W/RTS,  Tally switch MAKE/V, KAC power socket AC

Parts and their functions (Continued)

IINCOM switches [1/ 2]

This switch allows you to switch the intercom to be input to the COMMUNICATION connector  between 1 and 2 to enable calls with the selected camera.

Initial value: [1]

[4W/RTS]

This switch allows you to switch the system of the intercom signal to be input to the COMMUNICATION connector  between 4-wire (4W) and RTS.

Initial value: [4W]

zzWhen using the unit and camera combined on a one-to-one basis instead of using the intercom equipment on the system side, set this switch to the 4W position.

zzIf you set this switch to the RTS position, be sure to connect an RTS system.

zzWhen using the unit with an RTS system, terminate pins 1 and 3 of the COMMUNICATION connector  using a terminating resistor (200 Ω). (In the case of intercom signal 2, terminate pins 14 and 16.)

Refer to “Connector pin assignment table” of <Operations and Settings> (page 38).

TALLY switch [MAKE/V]

This switches the interface for the tally signal to be input to the COMMUNICATION connector  between contact type (MAKE) and voltage type (V).

Initial value: [MAKE]

KAC power socket [AC IN ]

This socket is for inputting AC power.

Connect the supplied power cable, and use a 3-prong outlet and ground the unit properly.

Grounding terminal [SIGNAL GND]

Connect this to the system ground.

15