Operating precautions (continued)

If insect sprays or other volatile substances are being used in the area, take care that they do not come in contact with the unit.

•These can warp the unit or cause the finish to come off.

•Do not leave the unit in contact with rubber or PVC products for extended periods of time.

After use, turn off the power of the recorder, and then remove the camera head option cable.

Do not point the lens at the sun.• Doing so may damage the parts inside.Caution regarding laser beams•The image sensor may be damaged if it is subjected to light from a laser beam.

When using the unit in locations where laser irradiation equipment is used, be careful not to allow the laser beam to shine directly on the lens.

Cleaning

When cleaning, do not use benzene or thinner.

•Using benzine or paint thinners may deform the camera head and/or cause the surface finish to peel off.

•Before proceeding with maintenance, disconnect the camera head option cable from the camera head.

•Use a soft, clean cloth to wipe the camera head. To remove stubborn dirt, wipe the camera head with a cloth moistened with kitchen detergent that has been diluted with water and then use a dry cloth to take up the remaining moisture.

E-7