19
Adjustment
Preset memories
This unit enables up to 100 settings for the camera direction
(panning and tilting), zoom, focus, iris, gain and white
balance to be registered in its preset memories, and called.
However, the number of settings that can be registered and
called depends on the type of wireless remote control or
controller that is used for operation.
The focus and iris operating modes (manual and auto
settings) are neither registered nor recalled.
The current focus and iris values are registered.
The focus and iris values can be recalled only when the
manual settings are applicable.
For the white balance, the current White Balance Mode
adjustment values are registered. If a preset value
is recalled when AWB A or AWB B is selected, the
adjustment value selected when it was registered as a
preset will be recalled.
The White Balance Mode (ATW, AWB A or AWB B)
stored using the AW-RP655 are recalled only when the
AW-RP655 is connected.
When there is a large difference in the environmental
temperature between the time of registration and the
time the setting is called, displacement of the preset
position may occur.
If displacement occurs, perform registration again.
When a manual operation is performed for pan, tilt,
zoom, focus or iris during preset recall, the preset
operation for the pan, tilt, zoom, focus or iris operation
concerned will be aborted.
If another preset has been recalled during an ongoing
preset recall, the preset being recalled is aborted,
and operation for the preset called last is performed
instead.
Notes
When performing the operations
using the wireless remote control
Twelve settings (preset No.1 to No.12) can be registered and
called using the wireless remote control.
The [1] to [12] buttons correspond to the unit’s preset
memories No.1 to No.12.
Registering the settings in the preset memories
1 Display the picture to be shot on the monitor.
Operate the pan, tilt or zoom buttons to determine the
camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
2 While holding down the [PRESET] button, press
the button corresponding to the preset memory
number.
If a preset memory number with an already registered
setting has been selected, the existing setting will be
erased and replaced with the new one.
Calling the settings of the preset memories
1 Press the button in which the preset memory