58
Web setting screen (continued)

Power ON button / Standby button

The unit’s power is turned on when the Power ON button
is pressed.
When the Standby button is pressed, the unit is set to the
standby mode.
While the standby mode is established, the control over
the camera’s operations exercised on the Control screen
and the Image button on the Setup screen is disabled.
If Power ON or Standby is selected too quickly,
the status selected and the display shown may not
correspond.
In a case like this, press the F5 key to restore the
correct status display.
When operation is transferred to the STANDBY
mode: The current zoom, focus and iris positions
are stored in the memory (POWER ON preset).
When operation is transferred to the POWER ON
mode: The zoom, focus and iris are transferred
to the positions which were stored in the memory
(POWER ON preset) when operation was
transferred to the STANDBY mode.
Notes

Operation lock button (Op.Lock)

Use this to lock the operation of the pan, tilt,
zoom, focus, brightness, speed, preset and
scene operations on the control screen.
Use this also to lock the on-screen display
menu operations, CAM/BAR and Power ON
button/Standby button to prevent operations
from being performed by accident.