Problem
A message other than “Networks is OK.” is displayed when Connection Test is performed.
Check | Remedy | 08 |
| ||
Is “Network is FAILED.” | • Check that this player and the Ethernet hub (or router with a hub |
|
displayed? | functionality) are properly connected. |
|
•If the IP address is obtained using the DHCP server function, check the setting is correct at the Information (page 41). For details on the DHCP server function, see the operating instructions for the Ethernet hub (or router with a hub functionality).
•Set the IP address manually.
•Check the operation and settings of the DHCP server function of the Ethernet hub (or router with hub functionality). For details on the DHCP server function, see the operating instructions for the Ethernet hub (or router with a hub functionality).
•If this player has been set manually, reset the IP address of this player or other components.
Is the Ethernet hub (or router | • Check the settings and operation the Ethernet hub (or router with a |
with a hub functionality) | hub functionality). For details, see the operating instructions for the |
operating properly? | Ethernet hub. |
| • Reboot the Ethernet hub (or router with a hub functionality). |
Others
Problem | Check | Remedy |
The player’s power turns off | Is Auto Power Off set to 10 If Auto Power Off is set to 10 min/20 min/30 min, the player’s power | |
automatically. | min/20 min/30 min? | turns off automatically if no operation is performed for over 30 minutes |
|
| (page 43). |
The player’s power turns on Is Control set to On? automatically.
The player’s power may turn on together with the power of the TV connected to the HDMI OUT terminal. If you do not want the player’s power to turn on when the TV’s power is turned on, set Control to Off (page 41).
The player cannot be operated with the remote control.
Are you operating the remote | Operate from within 7 m of the remote control sensor. |
control from a point too far |
|
away from the player? |
|
|
|
Are the batteries dead? | Replace the batteries (page 5). |
Input of the connected TV and AV system switches automatically.
Is Control set to On?
The input of the TV and AV system (AV receiver or amplifier, etc.) connected to the HDMI OUT terminal may automatically switch to the player when playback starts on the player or the menu screen (Home Media Gallery, etc.) is displayed. If you do not want the inputs of the connected TV and AV system (AV receiver or amplifier, etc.) to switch automatically, set Control to Off (page 41).
Settings I have made have been cleared.
•Have you disconnected the power cord while the player’s power was on?
•Has there been a power failure?
Always press STANDBY/ON on the player’s front panel or
STANDBY/ON on the remote control and check that POWER OFF has turned off from the player’s front panel display before disconnecting the power cord. Be particularly careful when the power cord is connected to the AC outlet on another device because the player turns off in conjunction with the device.
59
En