Main Menu (continued)

g About WFM

You can display the wave form monitor using the “WFM” function.

The display changes each time you press one of the buttons, [FUNCTION1] to [FUNCTION5] (J page 22), assigned with the [WFM] function (To use the “WFM” function, you must assign it to one of the [FUNCTION1] to [FUNCTION5] buttons).

Press the FUNCTION button assigned with the WFM function once.

Normal window

WFM display

Press the same button again.

 

 

 

 

 

 

 

WFM (Wave Form

 

Monitor)

The window is displayed in 16:9 aspect.

 

Restrictions on WFM

Even if “WFM” has turned ON”, “WFM” is not displayed when using the “PIXEL TO PIXEL” function, “YPBPR/RGB” set in “INPUT SELECT” menu is “RGB-COMP.” or “RGB-VIDEO”, or using the “SUB WINDOW” function.

g About PIXEL TO PIXEL and PIXEL POS.

Using the “PIXEL TO PIXEL” function, you can confirm a picture with the actual pixel count (only when the input is an HD signal).

First, press one of the buttons, [FUNCTION1] to [FUNCTION5] (J page 22), assigned with the “PIXEL TO PIXEL” function to turn it “ON”. With the function on, press another one of the buttons, [FUNCTION1] to [FUNCTION5] (J page 22), assigned with “PIXEL POS.”. Each time the button assigned with “PIXEL POS.” is pressed, the signal display position switches. (To use the “PIXEL TO PIXEL” function, “PIXEL TO PIXEL” and “PIXEL POS.” must be assigned to any two of the buttons, [FUNCTION1] to [FUNCTION5].)

 

 

The underlined values are factory preset setting values.

Sub menu

Settings

Explanation

 

PIXEL TO PIXEL*1*2

<OFF>

Used to set the input signal size as the display size.

 

<ON>

Compatible formats

 

 

1080/60I/59I/50I/30P/29P/25P/24P/23P/24PSF/23PSF,

 

 

720/60P/59P/50P(SDI/YPBPR)

 

 

 

PIXEL POS.

<CENTER>

Used to set the signal display position when PIXEL TO PIXEL

 

<LEFT TOP>

is on.*3

 

 

<RIGHT TOP>

<CENTER>

center

 

<RIGHT

<LT>

top left

 

BOTTOM>

<RT>

top right

 

<LEFT

<RB>

bottom right

 

BOTTOM>

<LB>

bottom left

 

 

 

 

*1 When PIXEL TO PIXEL is on, the following menu settings become invalid: “ON” for “ANAMO” and “UNDER” for “SCAN” set in “VIDEO CONFIG” Various “HV DELAY” settings in “FUNCTION”

“MARKER display”

*2 When the input signal is “SDI1”, “SDI2” or “YPBPR”, the setting takes effect. However, 1080/60P and 1080/50P signals are excluded.

*3 When the input signal format is 720, only CENTER is displayed.

25