Controls and Their Functions (continued)

Front panel

POWER

VIDEO Y/C SDI 1 SDI 2

YPBPR/

MENU

ENTER

 

FUNCTION

 

 

 

 

RGB

 

 

 

 

 

 

 

 

INPUT SELECT

 

 

1

2

3

4

5

PHASE CHROMA BRIGHT CONTRAST/ VOLUME

 

 

 

 

 

 

 

 

BACKLIGHT

POWER switch

This switches the power supply ON/OFF. When the power is ON, the LED (green) lights up.

INPUT SELECT button

This selects the signal input line. The green LED light above the button indicates the selected input signal.

VIDEO

:

Video input

Y/C

:

Y/C input

SDI1

: Serial digital interface input (HD/SD compatible)

SDI2

: Serial digital interface input (HD/SD compatible)

YPBPR/RGB

:

Analog component (YPBPR) or RGB input. Also compatible with PC input RGB.

*When using PC Input, select “RGB-COMP.” from “YPBPR/RGB” in the “INPUT SELECT” menu (Jpage 27).

*The monitor retains the input signal settings selected from the last time the monitor was swiched ON or OFF.

MENU button

This is used for menu display, selecting settings, and adjustments.

MENU

: Push to display or exit the menu, and to return to the previous menu screen.

,: Push to move the cursor up or down, or to select an item.

ENTER

: Push to confirm a setting, and to display a submenu.

FUNCTION button

FUNCTION 1 : Carries out the item selected in the menu.

FUNCTION 2 : Carries out the item selected in the menu.

FUNCTION 3 : Carries out the item selected in the menu.

FUNCTION 4 : Carries out the item selected in the menu.

FUNCTION 5 : Carries out the item selected in the menu.

Picture adjusting knob

PHASE

0

– 60

(30)

CHROMA

0 – 60

(30)

BRIGHT

0

– 60

(30)

CONTRAST

0

– 60

(50)/BACKLIGHT 0 – 60 (60)

( ) denotes factory preset values

A rotating knob that can be pushed to operate. When the picture adjusting knob is pressed, its status is displayed and adjustment becomes possible. The setting values are saved by pushing the knob again.

When values are changed from the factory preset values, the LED above the knob (amber) lights.

The setting values are loaded when the monitor’s power is switched ON. The setting values are saved when the knob is pushed, or when 10 seconds pass after changing the settings. However, operating changes cannot be made in the following cases.

*When the control lock is on, the key mark appears and setting values cannot be changed (J page 29).

*Only items selected in the menu can be adjusted with [CONTRAST] and [BACKLIGHT] (J page 21).

*When the MONO function is ON (J page 19), [PHASE] and [CHROMA] operations are disabled.

*When using “RGB-COMP.” input, [PHASE] and [CHROMA] operations are disabled.

*While operating HV DELAY (J page 24) (when set to any other setting than OFF), [BRIGHT] operation is disabled.

Volume knob

You can adjust the speaker volume by rotating the volume knob.

Speaker

Audio input from the AUDIO input terminal or SDI terminal (embedded audio) can be heard. Audio output setting is in the menu.

9