Supplying the power
Using an AC power supply | 3 Set the unit’s power switch to ON. |
| When using an external power supply other than the |
1 Connect the DC OUT connector on the | |
DC input connector and use the polarities correctly. | |
adapter to the DC IN socket on the unit. |
|
DC IN socket
14
2 3
External DC input socket
Pin no. | Signal |
|
|
1 | GND |
2, 3 | – |
4 | +12V |
AC adapter
2 Set the power of the AC adapter to ON.
<Notes>
≥DC cords should be no longer than 2 meters. Use of cords any longer than 2 meters may result in noise appearing on the screen.
≥Power from the AC adapter takes precedence when both a battery pack and AC adapter have been connected. It is also possible to attach/remove a battery while the AC adapter is being used.
≥When using the AC adapter, be absolutely sure to first set the power of the AC adapter to ON and then set the unit’s power switch to ON.
≥A voltage of 20V or more will not be indicated accurately on the battery voltage display.
Cosmetic screws
Screwsa4 | A total of eight cosmetic screws are provided with the |
| monitor for use at such times when the main controls have |
| been relocated. (Refer to page 8) |
| Since these screws also serve to protect the internal |
| mechanisms, do not leave the screw holes empty but place |
| the screws inside them and tighten them up. Any screws |
| which are not being used should be kept in a safe place. |
| Screwsa2 |
Screwsa2
10
