22
VF CONFIG
The underlined values are factory preset setting values.
Sub menu Settings Explanation
VF CONTROL VF-CH
ALL-CH
Used to select the input line for the VF function of the monitor.
(VF function: tally lamp lit, zebra displayed, displayed)
<VF-CH> Only enabled when the VF line is selected.
<ALL-CH> Enabled with all input lines.
CROSS HATCH HIGH
LOW
OFF
Used to set whether to display a cross hatch and select its density
level.
<HIGH> 70/256 (displays with a dense cross hatch)
<LOW> 20/256 (displays with a light cross hatch)
<OFF> Not displayed.
REAR TALLY ON
OFF
Used to allow control of the tally lamp on the rear of the monitor.
<ON> Lamp lights when TALLY control from a GPI/camera is ON.
<OFF> Lamp does not light.
ZEBRA ON
OFF
Used to set ZEBRA information in the camera.
<ON> Sets the information to ON.
<OFF> Sets the information to OFF.
RETURN CH∗1∗2YPBPR
VF
VIDEO
SDI
Used to select the signal input line by operating the RETURN (RET)
button of the camera lens.
<Note>
When there is no SDI input unit (option), the SDI item is displayed in
gray and cannot be set.
• The priority sequence for GPI control and RS-232C is as follows: GPI > VF CONFIG > RS-232C.
∗1 RETURN CH operates when VF CONTROL is set to ALL-CH. It is not affected by the various line ON/OFF
settings in the INPUT SELECT menu (→ page 29). (Input lines that are set with RETURN CH are enabled even
if they are set to OFF in INPUT SELECT.)
∗2 A function to be used with future Panasonic camera-recorders.
Main Menu (continued)