Using the Drive
Setting a Disc
1 Power on your computer.
2 Open the disc tray.
Press the eject button and slowly pull out the tray.
3 Place a disc.
①Place the disc with the label facing upward in
the drive.
E | ② Push down until the center holder clicks. | |
<Removing a disc> | ||
| ||
| ||
| Place a finger on the center holder and lift up on the | |
| edge of the disc. | |
| 4 Close the disc tray. | |
| ||
| Close the tray without touching the eject button. |
Label side up
Eject Button
Center Holder
CAUTION
After the tray closes, do not access the drive until the multimedia pocket device status indicator 
goes off.
If the vibration of the drive is excessive, check to see if the disc is inserted correctly, and check that the disc is in good condition. If the disc is good and inserted correctly, set [CD/DVD Drive Speed] or [CD Drive Speed] to [Low] in the Setup Utility. (This setting does not work for the DVD disc when using
Power-saving Mode
If the drive has not been accessed within 30 seconds, the drive motor will automatically shut down to reduce the power consumption. When the drive is accessed once again, the power of the drive motor is turned on. However, approximately 30 seconds are required until data is actually read from the disc.
8
