General
This chapter explains how to turn on or off the power, how to adjust the volume, etc.
Power On/off
(PWR: POWER)
Power on
Press [SOURCE] (PWR: POWER).
Power off
Hold down [SOURCE] (PWR: POWER) until you hear a beep, then release it.
| L |
|
|
|
|
|
USH | S E / | SRS | W |
| SOURCE | PWR |
LP |
|
|
| |||
O |
|
| O |
|
| |
V |
|
|
| W | SQ |
|
|
|
|
|
|
| |
|
|
|
|
|
| MENU |
|
|
|
|
| TUNE |
|
|
|
|
|
| TRACK |
|
|
|
|
|
| ||
MUTE | D・M |
|
|
|
| |
|
|
| LIST | |||
|
|
|
|
| ||
/ /SET/APM |
| TILT |
BAND | DISP | OPEN |
You can remove the face plate to prevent it from being stolen.
Face Plate Removing/Mounting
Removing
1 Turn off the power (a page 12)
2 Press [ 
]
(The face plate disen- gages with a click
when it is removed.) | / /SET/APM | TILT |
BAND DISP | OPEN | |
|
|
The face plate automatically closes after a lapse of 5 seconds while it is open.
The power is automatically turned off while the unit is active.
3 Put the face plate in the case.
Cautions
¡It is recommended to remove or mount the face plate when the plate is at the closed position. Do not remove or mount the face plate when the plate is in motion.
¡This face plate is not waterproof. Do not expose it to water or excessive moisture.
¡Do not remove the face plate while driving your car.
Mounting
1 Slide the left side of the face plate in place.
2 Press the right end of the face plate until “click” is heard.
¡Do not place the face plate on the dashboard or nearby areas where the temperature rises to high levels.
¡Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts.
¡If dirt or other foreign substances get on the con- tacts, wipe them off with clean and dry cloth.
¡To avoid damaging the face plate, do not push it down or place objects on it while it is open.
12
