Panasonic CQ-C9901U, CQ-C9801U, C9701U operating instructions Preparation, Clock adjustment

Preparation

When the power is switched on for the first time, a demonstration message appears on the display. Press [DISP] to change to regular mode.

SRCCS

On	1 Set your car’s ignition switch to the ACC
TimeFirstPower (DEMONSTRATION)	or ON position.
	2 Press [DISP] (Display).
	The demonstration screen appears.
	Example: CQ-C9901U
	The demonstration screen is cancelled, and no more		Note: If you would like to turn on the power and make
	appears.		the demonstration message appear, hold down [SRC]
			(PWR: Power) for 4 sec. or more after turning off the
			power in other than the XM mode.
	Preparation Before Initial Use		Warning
	Pull the insulation film out		¡Keep batteries and insulation film out of reach of
Preparation	from the backside of		infants. If an infant ingests a battery, please seek
	remote control gently.		immediate medical attention.
			Caution
			¡ Remove and dispose of an old battery immediately.
	Insulation film		¡ Do not disassemble, heat or short a battery. Do
	Battery Replacement		not throw a battery into a fire or water.
Control			¡ Follow local regulations when disposing of a
	q Remove the battery holder	Tough pointed object	battery.
			¡Improper use of a battery may cause overheat-
	with the remote control unit	Back side
	placed on a flat surface.		ing, an explosion or ignition, resulting in injury
Remote	q Stick your thumbnail into		or a fire.
	the groove, and push the		Note:
	holder in the direction of
			¡Battery Information:
	the arrow, and at the
	same time.	w	Battery Type: Panasonic lithium battery (CR2025)
	w Pull it out in the direction	q	(Included in the remote control)
	of the arrow using a	2	Battery Life: Approximately 6 months under nor-
	tough pointed object.
			mal use (at room temperature)
	w Put a battery in the case with

(+)side facing up. e Put the case back.

3

FunctionSecurity Setting	The following functions are activated when the Security	¡ The alarm sounds and the message appears on the
	Function is ON. (a page 38)	screen to warn you to remove the face plate at power
	¡ The security indicator blinks when removing the face	off.
	plate.
	Security Indicator

		You may need to set the following depending on the
		devices to be connected.
		Using Subwoofer
		¡ Subwoofer level adjustment (a page 36)
		¡ Subwoofer low pass filter (a page 36)
		Connecting an XM DirectTM receiver
		Preparation:
		¡ Connect the optional XM DirectTM receiver (XMD1000).
		¡ To connect the XM DirectTM receiver (XMD1000), it is
Settings		required to use an optional extension cord (XMDPAN100)
		that is produced by XM exclusively for Panasonic prod-
		ucts.
		Getting Started
		It is required to sign up to become an XM Satellite Radio
Other		subscriber. After checking your XM Satellite Radio ID,
		sign up on the XM’s website or by calling them.
		1 Check of XM Satellite Radio ID
		¡ Write down the ID indicated on the lower right of
		your XM DirectTM receiver (XMD1000).
		¡ Check the ID shown by tuning your XM Radio to
		channel 0. (a page 30)
		2 Activate the XM Satellite Radio
		Select either of the below to sign up.
		¡ Web site: http://www.xmradio.com/activation
		¡ Phone number: 1-800-XM-RADIO (96-72346)
		Note: Refer to the operating instructions for the XM
		DirectTM receiver for details.
		Note: Adjust the clock when “ADJUST” appears on the
		display.
Clock adjustment		1 Press [MENU] to display the menu dis-
		play.
	(CLOCK ADJ)	For using the remote control, hold down [MENU]
		for 2 sec. or more.
		2 Press []] or [[] to display the DIS-
		PLAY menu.
		3 Press [{] to select “CLOCK ADJ”.
		4 Press [BAND] (SET) to confirm the dis-
		play.

Connecting an AV device (TV, VTR)

If you connect TV to AUX1 terminal, set the AUX1 setting		English
1 Press [SRC] (Source) to select the
to TV.
AUX1 mode. (a page 16)
2 Press [MENU] to display the menu dis-
		Preparation
play.
For using the remote control, hold down [MENU]
for 2 sec. or more.
3 Press [BAND] (SET) to adjust.
	: TV
	: Other devices (Default)
Note: When using an external TV unit manufactured by
a third party, select the TV mode.
4 Press [MENU] to confirm the adjust-
ment.

5 Adjust the setting value.

[[]: Adjusting minutes

[]]: Adjusting hours

[}]: Forward

[{]: Backward

6 Press [BAND] (SET) to confirm the adjustment.

7 Press [MENU].

For using the remote control, hold down [MENU] for 2 sec. or more.

12 CQ-C9901U/C9801U/C9701U CQ-C9901U/C9801U/C9701U 13