Panasonic CQ-VD7003U warranty Front, Center, Sub W, Phase, ¡Sur

English

35

Settings (continued)

(AUDIO continued)

SP SETUP (Speaker set up)

Setting the absence/presence and size of each speaker

FRONT (Front speaker setting)

SMALL : for small speakers, or when bass playback is not possible

LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)

default: LARGE

CENTER (Center speaker setting)

NONE : when not using a center speaker

SMALL : for small speakers, or when bass playback is not possible

LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)

default: NONE

*A center speaker (option, EAB-CF2 recommended) is required.

SUR (Surround speaker setting)

NONE : when not using a surround speaker

SMALL : for small speakers, or when bass playback is not possible

LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)

		default:	LARGE
SUB - W		(Subwoofer speaker setting)
	: when not using a subwoofer
NO
	: when using a subwoofer
YES

default: NO

*A subwoofer (option, CJ-SW3003 recommended) is required. A power amplifier (option) is also required for connecting a subwoofer.

Note:

¡While the private mode is active, only FRONT can be adjusted.

PHASE (Phase setting)

0° : subwoofer phase 0 degree

180° : subwoofer phase 180-degree inverted

Note:

¡This setting is feasible only when SUB-Wis set to YES .

default: 0°

SP LEVEL (Speaker level)

Adjusting the output balance of each speaker

FRONT L		(Left front speaker output bal-
		ance)
] : down,	[ : up
		(Center speaker output bal-
CENTER
		ance)
] : down,	[ : up
		(Right front speaker output
FRONT R
		balance)
] : down,	[ : up
		(Right surround speaker out-
R¡SUR
		put balance)
] : down,	[ : up
		(Left surround speaker output
L¡SUR
		balance)
] : down,	[ : up
		(Subwoofer speaker output
SUB - W
		balance)
] : down,	[ : up

Setting range: – 10 dB to + 10 dB (1 dB steps) default: ± 0 dB for all speakers

¡If the speaker setting is NONE (none) or NO (no) for a

speaker, the test signal is not output and that speaker cannot be selected.

¡Turn rotary volume controller or press [+] or [–] (VOL) to adjust the volume of the test signal.

36

CQ-VD7003U