Panasonic CZ-64ESMC1U manual „Functions of buttons Continued

„Functions of buttons (Continued)

D: ON button					This button is for turning the selected air conditioner on.
E: OFF button					This button is for turning the selected air conditioner off.
F: Operation lamp					This lamp lights when the unit is turned on.
G: MODE button					Use this button to select one of the following fi ve operations:
	(AUTO)					: Used to automatically set cooling or heating operation.
						Only for heat pump type
										(temperature range: 62 to 80 °F)
	(HEAT)					: Used for normal heating operation.
						Only for heat pump type
										(temperature range: 60 to 78 °F)
			(DRY)			: Used for dehumidifying without changing the room temperature.
										(temperature range: 64 to 86 °F)
	(COOL)					: Used for normal cooling operation.
										(temperature range: 64 to 86 °F)
			(FAN)			: Used to run the fan only, without heating or cooling operation.
					When the			indication is displayed, you cannot change the mode from
	NOTE
					and or			to	or and	. To change the mode, turn off all units once
					then select the mode again.
H: Temperature setting							: Press this button to increase the temperature setting.
buttons							: Press this button to decrease the temperature setting.
I: FAN SPEED button
	(AUTO)					: The air conditioner automatically decides the fan speed.
				(HI.)		: High fan speed.
		(MED.)				: Medium fan speed.
				(LO.)		: Low fan speed.
J: FLAP button					1. Use this button to set the airfl ow direction to a specifi c angle.
						The airfl ow direction is displayed on the remote controller.
						Operation mode				Number of airfl ow direction settings
						(COOL) or			(DRY)		3
						(HEAT) or			(FAN)		5
						(AUTO)
						Cooling mode:					3
						Heating mode:					5
						• In the cool mode and dry mode, when the flaps are set in a
						downward position, condensation may form and drip around the
						vent.
						• Do not move the flap with your hands.
					This function is available only for models U1 and T1.
	NOTE
(				)	2. Use this button to make the airfl ow direction sweep up and down
						automatically.
						Press this button several times until the (					) symbol appears on the
						display.
					This function is available only for models U1, K1 and T1.
	NOTE
					1) The fl ap setting can be performed only for units that have no remote
	NOTE
						controllers.

2)In the ALL or ZONE mode, no fl ap setting can be performed. If necessary, you should select the GROUP mode and use the FLAP button.

5

01_CZ-64ESMC1U_EN.indd 5

2011/11/04 17:46:26