Lantronix LX6 manual To Configure Tunnel Connect Mode Settings, Disconnect Mode

	6: Line and Tunnel Settings
Tunnel Connect Mode	Description
Settings (continued)
Email on Disconnect	Select an email profile number to which an email notification will be sent upon
	the disconnection of an accept mode tunnel.
CP Output	Enter the CP Output Group whose value should change when a connection is
	established and dropped. Connection Value specifies the value to set the CP
	Group to when a connection is established. Disconnection Value specifies the
	value to set the CP Group to when the connection is closed. To display the
	“Connection Value” and “Disconnection Value”, first enter a “CP Output Group”,
	then click outside that field.

To Configure Tunnel Connect Mode Settings

Using Web Manager

To configure the Connect Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Connect Mode.

Using the CLI

To enter the Tunnel 1 Connect Mode command level: enable -> tunnel 1 -> connect

Using XML

Include in your file: <configgroup name="tunnel connect" instance="1">

Disconnect Mode

Specifies the optional conditions for disconnecting any Accept Mode or Connect Mode connection that may be established. If any of these conditions are selected but do not occur and the network disconnects to the device, a Connect Mode connection will attempt to reconnect. However, if none of these conditions are selected, a closure from the network is taken as a disconnect.

	Table 6-7 Tunnel Disconnect Mode Settings
Tunnel Disconnect	Description
Mode Settings
Stop Character	Enter the Stop Character which when received on the Serial Line, disconnects the
	tunnel. The Stop Character may be designated as a single printable character or
	as a control character. Control characters may be input in any of the following
	forms: <control>J or 0xA(hexadercimal) or \10 (decimal). Disable the Stop
	Character by blanking the field to set it to <None>.
Modem Control	Set whether Modem Control enables disconnect when the Modem Control pin is not
	asserted on the Serial Line. Choices are:
	 Enabled
	 Disabled (default)
Timeout	Enter the number of milliseconds a tunnel may be idle before disconnection. The
	value of zero disables the idle timeout.
Flush Serial Data	Set whether to flush the Serial Line when the Tunnel is disconnected. Choices are:
	 Enabled
	 Disabled (default)

XPort® Pro Lx6 Embedded Device Server User Guide 35