Lantronix LX6 manual Network Settings, Network Interface Settings

5:Network Settings

The Network Settings show the status of the Ethernet interface/link and let you configure the settings on the device. Interface settings are related to the configuration of the IP and related protocols. Link settings are related to the physical link connection, which carries the IP traffic.

Notes:

Some settings require a reboot to take effect. These settings are noted below.

Wait a minimum of 25-30 seconds after rebooting the unit before attempting to make any subsequent connections.

The blue text in the XML command strings of this chapter are to be replaced with a user-specified name.

Network Interface Settings

Table 5-1shows the network interface settings that can be configured. These settings apply to Ethernet (eth0).

	Table 5-1 Network Interface Settings
Network Interface	Description
Settings
BOOTP Client	Select to turn On or Off. At boot up, after the physical link is up, the XPort Pro Lx6
	will attempt to obtain IPv4 settings from a BOOTP server.
	Note: Overrides the configured IPv4 address/mask, gateway, hostname, and
	domain. When DHCP is Enabled, the system automatically uses DHCP,
	regardless of whether BOOTP is Enabled. Changing this value requires you to
	reboot the device.
DHCP Client	Select to turn On or Off. At boot up, after the physical link is up, the XPort Pro Lx6
	will attempt to obtain IPv4 settings from a DHCP server and will periodically renew
	these settings with the server.
	Note: Overrides BOOTP, the configured IPv4 address/mask, gateway, hostname,
	and domain. Changing this value requires you to reboot the device.
	Note: Within Web Manager, click Renew to renew the DHCP lease.
IP Address	Enter the static IPv4 address to use for the interface. You may enter it alone or in
	CIDR format.
	Note: This setting will be used if Static IP is active (both DHCP and BOOTP are
	Disabled). Changing this value requires you to reboot the device. When DHCP or
	BOOTP is enabled, the XPort Pro Lx6 tries to obtain an IPv4 address from a DHCP
	or BOOTP server. If it cannot, the XPort Pro Lx6 generates and uses an Auto IP
	address in the range of 169.254.xxx.xxx, with a network mask of 255.255.0.0.
Default Gateway	Enter the IPv4 address of the router for this network.
	Note: This setting will be used if Static IP is active (both DHCP and BOOTP are
	Disabled).

XPort® Pro Lx6 Embedded Device Server User Guide 23