Others

Even if the external flash is turned off, the camera may enter the external flash mode when the external flash is attached. When you are not using the external flash, detach it.

When attaching the external flash, the built-in flash cannot be activated.

Do not open the built-in flash when an external flash is attached.

The camera will become unstable when attaching the external flash, it is recommended to use a tripod when taking picture.

Turn off the camera when removing the external flash.

Detach the external flash when carrying the camera.

When attaching the external flash, do not hold only the external flash because it may detach from the camera.

If you use the external flash when the white balance is set to [ ] finely adjust the white balance depending on the picture quality. (P85)

If you take pictures close to the subject in Wide, the vignetting effect may appear on the bottom of the recorded picture.

The external flash cannot be used while the stereo microphone (DMW-MS1; optional) is in use.

Read the operating instructions of the external flash for details.

Using the Protector/Filter (optional)

The MC protector (DMW-LMCH62; optional) is a transparent filter which affects neither the colors nor the amount of light, so it can always be used to protect the camera’s lens.

The ND filter (DMW-LND62; optional) reduces the amount of light to approximately 1/8th (equal to adjusting the aperture value 3 increments) without affecting the color balance. PL filter (DMW-LPL62; optional) will suppress the reflected light from a metal or non spherical surfaces (flat non-metallic surfaces, water vapour or invisible particles in the air), making it possible to take a picture with enhanced contrast.

Attach the filter.

A MC protector

B ND filter

C PL filter

Note

Do not attach multiple filters at the same time.

If the filter is tightened too much, you may not be able to remove it. Do not tighten it too much.

If the filter is dropped, it may be destroyed. Be careful not to drop it when attaching it to the camera.

Be careful not to get a fingerprint, dirt, etc., on the filter when it is attached, otherwise the focus may be adjusted to the lens, resulting in the subject being out of focus.

You can attach the lens cap or the lens hood when the filter is attached.

Refer to the instructions for each filter for details.

160 VQT2A61

Page 160
Image 160
Panasonic DMC-GH1K operating instructions Using the Protector/Filter optional, Attach the filter