Panasonic DMC-SZ7 119, Press 3/4 to select PC, and then press MENU/SET, Operate the PC

Connecting to other equipment

Acquiring of still pictures and [MP4] motion pictures (other than [AVCHD] motion pictures)

Preparations:

Turn on the camera and the PC.

Remove the card before using the pictures in the built-in memory.

Connect the computer and camera with the USB connection cable (supplied).

•Check the directions of the connectors, and plug them straight in or unplug them straight out. (Otherwise, the connectors may bend out of shape, which will cause a malfunction.)

•Do not use any other USB connection cables except the supplied one.

Use of cables other than the supplied USB connection cable may cause malfunction.

AUSB connection cable (supplied) B Align the marks, and insert.

Press 3/4 to select [PC], and then press [MENU/SET].

•If [USB Mode] (P46) is set to [PC] in the [Setup] menu in advance, the camera will be automatically connected to the PC without displaying the [USB Mode] selection screen.

•When the camera has been connected to the PC with [USB Mode] set to [PictBridge(PTP)], a message may appear on the PC’s screen. Close the screen by selecting [Cancel], safely remove the USB connection cable (P120), and set the [USB Mode] to [PC].

Operate the PC.

•You can save the images into the PC by dragging and dropping the image, or the folder with the image that you would like to transfer onto a different folder in the PC.

Note

•Use a battery with sufficient battery power. If the remaining battery power becomes low while the camera and the PC are communicating, the alarm beeps.

Refer to “Disconnecting the USB connection cable safely” (P120) before disconnecting the USB connection cable. Otherwise, data may be destroyed.

•Before inserting or removing a card, turn the camera off and disconnect the USB connection cable. Otherwise, data may be destroyed.

- 119 -