Panasonic DMC-GF1C Protect, When Multi has been selected, Repeat these steps for each picture

Advanced (Playback)

Note

•The number of prints can be set from 0 to 999.

•With a printer supporting PictBridge, the date print settings of the printer may take precedence so check if this is the case.

•It may not be possible to use the print settings with other equipment. In this case, cancel all the settings, and reset the settings.

•If the file is not based on the DCF standard, the print setting cannot be set.

•[PRINT SET] cannot be set for motion pictures recorded in [AVCHD Lite] and pictures that were taken with the [QUALITY] set to [ ].

P[PROTECT]

You can set protection for pictures you do not want to be deleted by mistake.

Select [PROTECT] on the [PLAYBACK] mode menu. (P28)

Press 3/4 to select [SINGLE] or [MULTI] and then press [MENU/SET].

[SINGLE][MULTI]

Select the picture, and then press [MENU/SET].

When [MULTI] has been selected

•Repeat these steps for each picture.

•The settings are canceled when [MENU/SET] is pressed again.

Press 2/1 to select Press 3/4/2/1 to

the picture. select the pictures.

Press [‚] to return to the menu screen.

•Press [MENU/SET] to close the menu.

∫Canceling all the [PROTECT] settings

1Select [CANCEL] on the screen shown in step 2 and then press [MENU/SET].

2Press 3 to select [YES] and then press [MENU/SET].

3Press [MENU/SET] to close the menu.

•If you press [MENU/SET] while canceling protection, the canceling will stop halfway.

Note

•The protect setting may not be effective on other equipment.

•Even if you protect pictures on a card, they will be deleted if the card is formatted.

•Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they cannot be deleted when the card’s Write-Protect switch is set to [LOCK].

VQT2G44 143