Troubleshooting, Before Calling Service | Panasonic DP-1510P

Troubleshooting

Before Calling Service

Check

Action

Unit Does Not Operate

Does the display light? (No)

Does the Energy Saver key flash (or light) and displays are turned OFF? (See page

24)

(No)

Does any of the U## codes and messages appear on the display?

(U01, U07, U13, U14, U20 and U21) (See page 54)

(No)

Does the add paper indicator and message appear on the display? (J)∗

(No)

Does the paper misfeed indicator and message appear on the display? (I)

(No)

Check if the Power Switch is turned On and that the power cord is connected into the outlet.

(Yes)

Press Energy Saver key on the Control Panel.

(Yes)

Perform actions in accordance with each message.

(Yes)

Add paper. (See page 42)

(Yes)

Remove the misfed paper. (See page 45)

(Yes)

Does E#-## indicator and message appear on the display?

Turn the copier Off, then On. If the Error Code does not clear, call for service.

(Yes)

When the Add Toner Warning Indicator begins to flash∗ or is lit, replace the toner bottle with a new one. After this warning is activated, machine operation will begin with the Toner Charging Mode

(approximately 3 minutes to complete) each time the power switch is turned Off then On or if the Front/Right Cover is opened and then closed.

Note: ∗When the warning indicator starts flashing, a 300-sheet count-down counter is activated, and upon reaching 0 the machine will stop operating. The 300-sheet counter is based on

6 % fill, depending on the density some pages may print Blank.

Machine operation and displays are as follows:

1.When turning the power switch to On or opening and then closing the Front/Right Cover, the machine starts to warm-up and the LCD displays:

PLEASE WAIT...

52

Image 52

Panasonic DP-1510P manual Troubleshooting, Before Calling Service, Check Action, Unit Does Not Operate

Contents

Options Before StartingEnglish Others Important Information Model and Serial Number Operation Chart Common Features and Usage Energy Star Table of Contents Options Problem SolvingOthers For Your Safety PrecautionsLaser Safety Handling Toner and Paper Ventilation Installation For U.K Control Panel Contents Refer to Stop Key LCD DisplayInterrupt Key, Memory in Key, M1/M2 Keys Copy Size Key Basic Copy Full Size CopyingCopying the Same Size Originals $Select Exposure Control Copying with Preset Ratios Reduction or Enlargement CopyingSelect the Copy Paper Tray key Zoom Copying ZoomPress Cursor G or F keys to select Zoom Ratio Select Original Using the Sheet Bypass $Adjust the side guidesCopying on Special Paper, etc Press Start Creative Features Procedure1 Copy Press Copy Place the Press Originals page Copy KeyPlaten Press BOOK, Edge Or Margin key Key Operation Sided/1-Sided Copy For DP-2010EBook \ Press 2-Sided \ 2 / 2 \1 / 2 \ 2 Copy For DP-2010ESided Copy key Book \ 2 Copy For DP-2010E Place the Original on the Platen Job Memory To Store a Job in MemoryTo Recall a Job Stored in Memory $Press the Memory in F2 key Sort Mode Sort CopySort Copy From Platen Glass only Other Features Energy Saver/Interrupt ModeEnergy Saver Mode Sleep Mode Skyshot Mode Digital Skyshot Mode Manual Skyshot Mode Platen Upper- left corner Combined Function Table RemarksNext Job Memory Retrieval Using Function Modes to Change the Initial Copy Modes Function Modes Function Initial Setting General Functions Copier Settings General Functions for Key Operator Copier Settings for Key Operator Function Setting Changing the Auto Exposure SettingPress the Function key Proceed as Follows Changing the Paper Size Function Setting for Key OperatorFunctions Indicator PaperStopper Guide a Paper Guide b Size Department Counter Select the Department Counter Mode Page Accessories Components Features Automatic Document FeederADF DA-AS180 / i-ADF DA-AR201 Components Operation PlaceOriginal Inappropriate Originals Adding Paper J Problem SolvingSheet Paper Tray Adding the Toner and Replacing Waste Toner Container ? Open the Front CoverRemove the Waste Toner Container by Slowly pulling it towards the left as Problem Solving Removing a Misfed Paper Paper Misfeed Locations Paper Exit Area Remove the misfed paper Paper Entry/Transport Area Open the Right Cover Remove the misfed paperHot Heated Open the Right Cover ADU Area For DP-2010E onlyClose the Right Cover Paper Feed Module ADF For DP-2010E only ADF Troubleshooting Before Calling ServiceCheck Action Unit Does Not Operate Light Copies Add Toner Warning IndicatorMarked Copies User Error Codes U Code As a rule, clean weekly Specifications DP-1510P/1810P/2010E Copier ADF DA-AS180 ADF DA-AR2012nd/4th Paper Feed Module DA-DS182 3rd Paper Feed Module DA-DS183 Options and Supplies For PrinterFor Network Printing SuppliesPage Page For Service, Call