FM transmitter
You can enjoy listening to discs or SD cards through your FM radio channel (e.g. car stereo) by transmitting audio signals from this unit.
pThe FM transmitter can also be used with normal FM
Preparation: Unplug headphones and audio/video cable from the unit.
pWhen connected, the FM transmitter will not work.
1Play the disc or SD card. (➜ page 12 or page 14)
2 |
|
|
|
|
| Press to display | FM TRANSMITTER |
| |
| ON | OFF | ||
| the menu. | STEREO | MONO | |
|
| |||
|
|
| 88.3 MHz |
|
If the menu is not displayed, check the “Preparation” steps listed above.
3 |
| Press [ | ] to select “ON”. |
|
|
| |||
| ENTER | The orange lamp next to the | ||
pNo sound is heard from this unit. For the volume on this unit, set the on screen volume level using the following indications.
–DVD movies: the far right side
–Others:near the middle
The above settings are to be used only as a rough estimate. Depending on the recording conditions of the disc or card, the actual appropriate volume level may differ. If the volume is inappropriate in step 5, readjust the volume.
4Tune the radio to the 88.3 MHz FM frequency.
When another FM broadcast is heard.
(➜ see below, “When this has not been successful”)
5 Adjust the volume using the radio.
To turn off the FM transmitter : Press | ] to select “OFF”. |
To exit the screen: Press |
|
Enjoying in a car
When this has not been successful
1
2
ENTER
Press to display the menu.
Press [ ] to select the frequency (“88.3 MHz”) (factory preset) .
Press [ ] , to select a frequency between
88.3MHz and 107.7 MHz which is not being used by any broadcasting stations.
pThe frequency can be set in 0.1 MHz increments.
3Tune the FM radio into the frequency selected in step 2.
pIf you experience noise or distortion of audio, move the radio antenna closer to the unit. Or select
“MONO” from the menu screen using []. If the audio quality still does not improve, then change the radio frequency (➜ above, “When this has not been successful”).
RQT8237
31
31
