Ref. No. 1E Procedure 1A →
→→
→1B →
→→
→1D →
→→
→1E Removal of the motor housing.
1. Remove the holder cap and take out the carbon brush on right and
left side.
2. Loosen four tapping screws (5X35) tighten the gear case.
3. Pull out the gear case assembly from the motor housing.
Ref. No. 1F Procedure 1A →
→→
→1B →
→→
→1D →
→→
→1E →
→→
→1F →
→→
→
1C
Removal of the gear case block.
1. Loosen two screws (M4X12) and pull out the rotor assembly.
2. Follow the procedure 1C.
NOTE:
Greasing No. 1 grease about 10g into the gear for reassembly.
5
EY3544-U1