EY3551-U1 / EY3552-U1
Ref. No. 3F 
Procedure 3A → 3B → 3C → 3D → 3E → 3F 
Assembly of the shoe.
1. Insert the spring pin with a rod having a diameter of 5mm.
NOTE:
Make sure that the slit part of spring is placed downward. And protrusion of spring pin should be uniform on both side.
2. Place the toothed lock washer inside and the stopper washer to the housing B.
3. Sliding the depth adjustment plate up with placing the stopper washer into the ditch of the depth adjustment plate.
4. Pass the square screw through.
5. Insert the pipe and place the spring wahser and piling catahats washer from housing A side with holding the square screw by hand. 6. Insert the hex nut and the shoe up (parallel to the main body).
7. Tighten the hex nut with the depth adjustment lever at 30kgfcm.
8. Set the depth adjustment lever.
NOTE:
Make sure that the depth adjustment lever is set about 14mm away from housing. If the gap between housing and lever is less than 14mm, take the lever out and turn 30degree toward your side and try to set again.
9. Attach the NEW
NOTE:
Please use the new
10
