5)Maintain power tools. Check for misalign- ment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
6)Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
7)Use the power tool, accessories and tool bits etc. in accordance with these instructions and in the manner intend- ed for the particular type of power tool, taking into account the working condi- tions and the work to be performed.
Use of the power tool for operations different from those intended could result in a haz- ardous situation.
Battery tool use and care
1)Ensure the switch is in the off position before inserting battery pack.
Inserting battery pack into power tools that have the switch on invites accidents.
2)Recharge only with the charger speci- fied by the manufacturer.
A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
3)Use power tools only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and fire.
4)When battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws, or other small metal objects that can make a con- nection from one terminal to another.
Shorting the battery terminals together may cause burns, or a fire.
5)Under abusive conditions, liquid may be ejected from battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
Service
1)Have your power tool serviced by a qualified repair person using only iden- tical replacement parts.
This will ensure that the safety of power tool is maintained.
WARNING
To reduce the risk of injury, user must read instruction manual.
II.SPECIFIC SAFETY RULES
1)Hold tool by insulated gripping sur- faces when performing an operation where the cutting tool may contact hid- den wiring.
Contact with a “live” wire will make exposed metal parts of the tool “live”and shock the operator.
2)Wear ear protectors when using the tool for extended periods.
Prolonged exposure to high intensity noise can cause hearing loss.
3)Be aware that this tool is always in an operating condition, it does not have to be plugged into an electrical outlet.
4)Do not operate the Forward/Reverse lever when the Variable speed control trigger is on.
The battery will discharge rapidly and damage to the unit may occur.
5)If the bit becomes jammed, immediately turn the Variable speed control trigger off to prevent an overload which can damage the battery pack or motor. Use reverse motion to loosen jammed bits.
6)When storing or carrying the tool, set the Forward/Reverse lever to the center (switch lock) position.
7)Do not strain the tool by holding the speed control trigger halfway (speed control mode) so that the motor stops.
8)During charging, the charger may become slightly warm. This is normal. Do not charge the battery for a long period.
Symbol | Meaning | |||||||
|
|
|
|
|
|
|
| |
|
| V | Volts | |||||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Direct current | |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
| n0 | No load speed | |||||
…/min | Revolutions or | |||||||
reciprocation per minutes | ||||||||
|
|
|
|
|
|
| ||
→Forward rotation
(Toward Chuck)
→Reverse rotation
(Toward Motor)
- 4 -
