Ref. No. 2G
Procedure 2A → 2B → 2C→ 2D→ 2E→ 2F→ Attachment of the Housing. 2G
1.Place the driving block onto the housing A and place the spring for release lever and the hook release lever.
2.Place the switch assembly, operation panel, click spring and F/R selector handle onto the housing A.
NOTE :
Make sure that the lead wires are pressed fit firmly.
3.Close the housing A and B with pushing the radiating plate on the direction of the arrow and tighten 8 housing screws.
NOTE :
Confirm to set the radiating plate properly. If the radiating plate lean toward the motor brush side, the housing B can not be closed.
4.Place the H/L change handle into the rail properly.
5.Insert the belt hook into the housing and tighten with hook bolt.
8