Panasonic EY7450 Switch and Forward/Reverse Lever Operation, Forward Rotation Switch Operation

Switch and Forward/Reverse Lever Operation

CAUTION:

Set the clutch setting at this mark ( ) before actual operation.

ForwardReverse

Switch lock

CAUTION:

To prevent damage, do not operate Forward/Reverse lever until the bit comes to a complete stop.

Forward Rotation Switch Operation

If the clutch handle cannot be set at “drilling” or “hammering” mode af- ter drilling with clutch function, set the clutch handle at position 1 and oper- ate the clutch for a second.

Speed Selection

Choose a low or high speed to suit the use.

LOW HIGH

1.	Push the lever for forward rotation.
2.	Depress the trigger switch slightly	The more the variable speed control trig-
	to start the tool slowly.
		ger is pulled, the higher the speed be-
3.	The speed increases with the amount
		comes.
	of depression of the trigger for efficient
	tightening of screws and drilling. The	WARNING:
	brake operates and the chuck stops
	immediately when the trigger is released.	• Do not inhale any smoke emitted
4.	After use, set the lever to its center
		from the tool or battery pack as it
	position (switch lock).	may be harmful.

Reverse Rotation Switch		CAUTION:
Operation		• Check the speed selector switch
1. Push the lever for reverse rotation. Check		before use.
		• Use at low speed when high torque
the direction of rotation before use.
2. Depress the trigger switch slightly		is needed during operation. (Using
to start the tool slowly.		at high speed when high torque
		is required may cause a motor
3. After use, set the lever to its center
		breakdown.)
position (switch lock).
		• Do not use the tool in a manner that
Clutch Torque Setting
		causes the motor to lock up. Doing
Adjust the torque to one of the		so may damage the tool and battery
		pack, resulting in smoke or fire.
18 clutch settings or " " position
		• Do not operate the speed selector
(EY7450).
Adjust the torque to one of the 18		switch (LOW-HIGH) while pulling on
clutch settings or " ", "	" position	the speed control trigger. This can
(EY7950).		cause the rechargeable battery to
NOTE:		wear quickly or damage the internal
		mechanism of the motor.
Always make sure to stop operation		* See specifications for "MAXIMUM
of the tool and disengage it from the
		RECOMMENDED CAPACITIES".
work, when you select Hammering
mode from Drilling mode or when you
shift to Drilling mode from Hammer-
ing mode by rotating clutch handle.

- 9 -

EY7442_7450_7950(UL).indb 9

2011-2-17 11:48:02