13
VQT3Y04
∫Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
≥Insert the battery until it clicks and locks.
∫Charging the battery
ADC input terminal
1Connect the AC cable to the AC
adaptor, then the AC outlet.
2Connect the AC adaptor to the DC input
terminal [DC IN].
≥The status indicator will flash red
for
approx. 2 seconds (off for approx. 1 second, on
for approx. 1 second),
indicating that
charging has begun.
It will turn off when the charging is
completed.
∫Inserting/removing an SD card
≥Check that the access lamp has gone off.
1) Open the SD card cover and insert/
remove the SD card into/from the card
slot B.
≥Face the label side C in the direction
shown in the illustration and press it
straight in as far as it will go.
≥Press the center of the SD card and then
pull it straight out.
2) Securely close the SD card cover.
≥Securely close it until it clicks.
Quick Guide
Access lamp [ACCESS] A
≥When this unit is accessing the SD
card or built-in memory, the access
lamp lights up.
HC-V100&V100MP_PC_PU_VQT3Y04_mst.book 13 ページ ２０１２年１月５日 木曜日 午前１０時２０分