Setup
Part names and functions
n Sensor unit
AB
C
n Magnet unit
D
Sensor unit cover
M
N
Used to confirm the status of the sensor or register the sensor to the hub.
LED indicator
Magnet unit cover
About the LED indicator
You can press M
N and check the LED indicator to confirm the sensor’s status.
Indicator | Status | ||
Green, lit |
| Window/door is closed |
|
|
|
|
|
Red, lit | Window/door is open | ||
|
|
|
|
Indicator | Status | |||
Red, |
| Sensor is out of range |
| |
blinking | of the hub | |||
|
|
|
|
|
Green, | Registration mode | |||
blinking | (You pressed and held | |||
|
| M | N) | |
|
|
|
|
|
Off | No battery power | |||
|
|
|
|
|
Note:
RThe LED indicator does not indicate sensor status if the sensor has not been registered (page 9).
Setup overview
1Initial setup
Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub.
2Insert the battery
The window/door sensor is battery powered.
3Registration
Required only if the window/door sensor was purchased separately (i.e., not as part of a bundle).
4Confirm the installation area Read the information in this document to confirm that the desired installation area is suitable to proper operation.
5Temporary placement Temporarily place the window/ door sensor in the desired location and confirm that it operates properly (page 11).
6Installation
Install the window/door sensor on the same position where proper
8For assistance, please visit www.panasonic.com/support
