Panasonic KX-TC2000ALB, KX-TC2000ALF, KX-TC2000ALS Making/Answering Calls, Making Calls

2 Making/Answering Calls

Section 2

2-A Making Calls

(TALK) and

Indicator

(REDIAL)

(LOUD)

(CH)

1 Press (TALK).

•The TALK indicator lights.

•If an alarm tone sounds, see 6-D.

2 Dial a phone number.

3 To hang up,

press (TALK) or place the handset on the base unit.

•The indicator light goes out.

•For best operating performance, see section 6-B.

•When dialling additional numbers after speed dialling [eg, AUTO (3-B), DIRECT (4-B) or REDIAL], make sure that speed dialling is finished before entering additional digits.

Otherwise, the unit may not dial correctly.

To redial the last number dialled

Press (TALK) \ (REDIAL).

To select the handset receiver volume

Press (LOUD) while talking.

•Each time you press the button, the volume level will change from LOW (preset) to HIGH.

If noise interferes with the conversation

Press (CH) to select a clearer channel or move closer to the base unit.

Backlit handset keypad

The handset dialling buttons will light when you press a button or lift the handset off the base unit, or when a call is received. The lights will go out a few seconds after pressing a button, lifting the handset or answering a call.

2-B Answering Calls

(TALK) and Indicator

(RINGER)

If the handset is off the base unit,

press (TALK).

•You can also answer a call by pressing any dialling button (0) to (9), (*) or (#)

(—Any Key Talk).

OR

If on the base unit,

just lift up.

Selecting the ringer volume

The TALK indicator light must be off.

•To select HIGH (preset) or LOW, press (RINGER).

Each time you press the button, the ringer volume will change and the selected volume will ring.

•To turn the ringer OFF,

press and hold (RINGER) until a beep sounds.

•To turn the ringer ON,

press (RINGER).

For New Zealand Users Only: Additional Security Feature

In the event that a call cannot be made from the handset following a power interruption, disconnect the base unit from the line momentarily then reconnect it. Turn the handset off, and replace it on the base unit.

This will re-establish the security system and the handset can be used as before.