Panasonic KX-TC2000ALF, KX-TC2000ALB, KX-TC2000ALS Battery Base Unit Location, Wall Mounting

6 Things You Should Know

6-A Battery 6-B Base Unit Location

Recharge

When the RECHARGE indicator flashes or the unit beeps intermittently, place the

Calls are transmitted between the base unit and the handset using wireless radio waves. For maximum distance and noise-free operation, the recommended base unit location is:

handset on the base unit for about

RECHARGE

15 hours to recharge the battery.

Battery information:

Indicator

After your Panasonic battery is fully charged:

Away from electrical appliances	In a HIGH and CENTRAL
such as a TV, personal computer,	location with no obstructions
cellular phone charging units	such as walls.
or another cordless phone.

Operation	Operating time
While in use (TALK)	Up to about 5 hours
While not in use (Standby)	Up to about 14 days

•The battery operating time may be shortened depending on usage conditions and ambient temperature.

•As preventative maintenance, clean the handset and the base unit charge contacts with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or humidity. Otherwise the battery may not charge properly.

•If the battery is fully charged, you do not have to place the handset on the base unit until the RECHARGE indicator flashes. This will

maximize the battery life.

•The battery cannot be overcharged.Extend fully.

Battery replacement:

If you cleaned the charge contacts and fully charged the battery, but after a few telephone calls, the RECHARGE indicator flashes, the battery needs to be replaced. Replace the battery with a new Panasonic P-P301 (KX-A36A) battery. See section 1-C, step 2. When replacing the battery, programmed information may be erased. Reprogram if necessary.

6-C Wall Mounting

This unit can be mounted on a wall.

1 Pull down the handset hook until it locks, so the

tab holds the handset.

3 Connect the AC adaptor. Tuck the telephone line cord inside the wall mounting adaptor, then push it in the direction of the arrows

(# and $).

•The word “UP WALL” should face upward.

To Power

Outlet

2

1

Press the tabs in
2 the direction of the
arrows (#), then
remove the wall
mounting adaptor	1	1
($).

Wall Template

8.3 cm

4 Connect the telephone line cord. Install screws using the wall template below. Mount the unit, then slide down.

2•Extend the antenna fully.

•Fasten the cords to prevent it

from being disconnected.

Hooks

Screws (not included)

8.3 cm

For Australia

To Telephone Plug

and Socket

OR

For New Zealand

To Single-Line

Telephone Jack