Handset Settings
11
(Enter a Direct Call
Number):
After a Direct Call phone number has
been entered and Direct Call set to
ON, you can call the Direct Call num-
ber only, by pressing ‰. Incoming
calls are accepted.
ZZVV.
Enter phone number.
ZZYY.
ZZVV
to save the entered number.
ZZSS/ UUto select oonn(On) or ooffff
(Off).
ZV.
If on is selected, ËËis displayed.
(Call Options):
ZZVV.
ZZSS/ UU.
(Select Talk Mode Display):
ZZVV.
ZZSS/ UUto select from ttaallkk
ttiimmee(Length of Call) or pphhoonnee nnoo
(Phone Number).
ZZVV.
(Select Standby Mode
Display):
ZZVV.
ZZSS/ UUto select from bbss nnoo
(Base Unit number), hhss nnoo
(Handset Number), cclloocckk(Clock)
or ooffff(Off).
ZZVV.
(Display Options):
ZZVV.
ZZSS/ UU.
(Set Battery Low Tone
ON/OFF)***
*** Program as follows:
ZZVV.
ZZSS/ UUto select ON/OFF.
ZZVV.
(Set Range Alarm ON/OFF)
***
To program see *** below.
Alarm will sound when you move out
of range of a base unit.
(Set Call Waiting Tone
ON/OFF)***
To program see *** below.
Call waiting tone sounds when an
incoming external call is received
during an intercom call.
(Set Key Confirmation
Tone ON/OFF)***
To program see *** below.
(Tone Settings):
ZV.
ZS/U.
! Time will only be displayed if
the clock has been set (see “Base
Unit Settings”).
(Set Call Prohibition
ON/OFF):
This allows you to make emergency
and intercom calls only.
ZZVV.
Enter handset PIN (4 digits).
If the PINis incorrect an error tone
sounds.
ZZSS/ UUto select oonn(On) or ooffff
(Off).
ZV.
If on is selected, Ôis displayed.
tone opt
call waiting
range alarm
battery low
display opt
standby mode
key tone
direct no
call bar
call opt
talk mode
Before programming, please follow steps 1 to 4 of ‘Handset Settings’.
650bx engversion 19 6 02 19/6/02 6:59 am Page 11