Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base unit. Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call. See side 5 for information on ordering additional handsets.
Vigtigt:
L The additional handset model recommended for use with this unit is noted on side 5. If other model handset is used, certain operations (handset settings, base unit settings, etc.) may not be available.
Registering a handset to the base unit
The included handset and base unit are preregistered. If for some reason the handset is not registered to the base unit (for example, w flashes even when the handset is near the base unit), register the handset manually (side 20).
To register an additional handset to the base unit (easy registration)
After purchasing an additional handset, register it to the base unit. Ensure that the additional handset is switched on. If it is not on, press and hold {ih} for few seconds to turn the handset on.
1Lift the additional handset and press {ih} to put the handset in standby mode.
2Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.
3Place the additional handset on the base unit. The registration tone continues to sound. With the handset still on the base unit, wait until a confirmation tone sounds and w stops flashing.
Bemærk:
L If an error tone sounds, or if w is still flashing, register the handset manually (manual registration; side 20).
LIf all registered handsets start ringing in step 2, press {x} to stop. Start again from step 1.
LCharge the batteries of your additional handset for about 7 hours before initial use.
L This registration method cannot be used for handsets that have already been registered to the base unit. Register the handset manually (manual registration; side 20).
To register a handset to the base unit (manual registration)
You can register a handset to the base unit manually using the following method.
1{j/OK} i“Indstil håndsæt” i{>}
2“Registrering” i{>}
3“Reg.Håndsæt” i{>}
4Press and hold {x} on the base unit for about 3 seconds, until the registration tone sounds.
L If all registered handsets start ringing, press {x} to stop, then repeat this step.
L After pressing {x}, the rest of this procedure must be completed within 1 minute.
5Wait until “Indt. base PIN” is displayed, then enter the base unit PIN (default: “0000”), then press {j/OK}.
L When the handset has been registered successfully, w will stop flashing. If keytones are turned on (side 15), a confirmation tone will be heard.
Cancelling a handset
A maximum of 6 handsets can be registered to the base unit. A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.
1{j/OK} i“Indstil base” i{>}
2Enter “335”.
3“Slet Håndsæt” i{>}
20
