Panasonic KX-TGA520C installation manual Registration, 2Handset

Registration

This cordless handset must be registered to a KX-TG5200C/KX-TG5202C/KX-TG5230C/ KX-TG5240C/KX-FPG391C base unit. The handset will be assigned the extension number at registration. Only one handset can be registered at a time. Charge the battery fully.

Make sure the base unit and the other handsets are not being used. Have both the handset and base unit nearby during registration.

*LOCATOR Button

CHARGE Indicator

1[-]

Press LOCATOR on base unit for 3 sec.

Then press OKL

BACK OK

To operate “ OK ”, press the right soft key.

•Base unit model shown here is KX-TG5240C.

*The location of the LOCATOR button varies by base unit model. KX-TG5200C/KX-TG5202C: LOCATOR [], [], [], [] or [] KX-TG5230C/KX-TG5240C/KX-FPG391C: [LOCATOR/INTERCOM/TRANSFER]

The handset display shows the instructions as shown on the right.

Press LOCATOR on base unit for 3 sec.

Then press OKL

BACK FRANÇ. O K

1Base unit: Press and hold the *LOCATOR button for 3 seconds.

•The CHARGE indicator flashes. After the CHARGE indicator starts flashing, the rest of the procedure must be completed within 1 minute.

•On the KX-FPG391C, “HS REGISTRATION” is displayed.

2Handset:

(1)Press the soft key ( OK ).

(2)Wait until a long beep sounds and the display shows the new extension number.

• Registration is complete.

IN USE SPIPRIVACY1[-]

Handset Registering

e.g. Extension number 2

IN USE SPIPRIVACY1[2]

Handset [2] Registered

•The registered number “[1]” to “[4]” is shown on the top right of the display.

•You can stop registration by pressing [OFF] on the handset and pressing the *LOCATOR button on the base unit.

•If you try to register this handset to the KX-TG6500C base unit, “Wrong handset Refer to manual” is displayed. The base units for this handset are mentioned above.

To cancel the handset registration, please see your base unit Operating Instructions.

– 3 –