Programming
without phone number feature is turned on. To turn the feature off: MERASEN a MCN a MSAVEN a MOFFN
Other programming
Changing the handset name
Each handset can be given a customized name (“Bob”, “Kitchen”, etc.). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. The default setting is “No”. If you select “Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1MMENUN#104
2Enter the desired name (max. 10 characters; page 17).
3MSAVEN
4MbN: Select the desired setting. a MSELECTN 2 times a MOFFN
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base unit.
Important:
RSee page 4 for information on the available model.
Registering a handset to the base unit
The supplied handset and base unit are
1Handset:
MMENUN#130
2Base unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop, then repeat this step.
3Handset:
Press MOKN, then wait until a long beep sounds.
Deregistering a handset
A handset can cancel its own registration to the base unit, or other handsets registered to the same base unit. This allows the handset to end its wireless connection with the system.
1MMENUN#131
R All handsets registered to the base unit are displayed.
2MbN: Select the handset you want to cancel. a MSELECTN
3MbN: “Yes” a MSELECTN a MOFFN
26For assistance, please visit http://www.panasonic.com/help
