Panasonic KX-TS108W 1, 2, 4, 3

For assistance, please call: 1-800-211-PANA(7262)

Battery Replacement

31

If “ ” ﬂashes, the battery power is low. Install new batteries. Replace

the batteries within 1 minute to keep the programmed settings. But the

programmed time setting will be cleared.

1Disconnect the telephone line cord

from the unit.

2Press down in the direction of the

arrow and remove the cover.

3Replace the batteries with new ones

using correct polarity (i, j), and

close the cover.

4Connect the telephone line cord to

the unit.

Battery Precautions:

The batteries should be used correctly, otherwise the unit may be damaged by

battery leakage.

—Do not mix different types of batteries.

—Do not charge, short-circuit, disassemble, heat or dispose of in ﬁre.

—Remove all the batteries when replacing.

Note:

—If you do not install the batteries or if the battery power is low, the time will

be shown as “12-00” and “ ” will ﬂash. Readjust the time.

—Replace all the batteries once a half year in use of Alkaline batteries, or

misoperation may occur. (When you use Manganese batteries, replace all of

them once in three months.)

—Do not use nickel-cadmium batteries.

≥If the time is shown as “12-00” and “ ” ﬂashes after replacing the batteries,

readjust the time.

+

-

-

+

+

-

1

2

Useful Information

Contents

Main Before Initial Use Accessories Contents Preparation Basic Operation Advanced Operation Useful Information Location of Controls Display Settings Connecting the Handset/Telephone Line Cord After connection, lift the handset to check for a dial tone. Installing the Batteries Connecting a Communication Device Programming Summary Dialing Mode 3 4 Time Adjustment 3 4 5 6 LCD Contrast 1 3 4 Ringer Volume Wall Mounting 1 2 3 Using the speakerphone 1 Making Calls 2 3 4 To redial the last number dialed Making Calls During speakerphone operation To adjust the handset volume (4 levels) or the speaker volume (8 levels) while talking To increase, press VOLUME (^). To decrease, press VOLUME (_). 1 2 3 Storing Phone Numbers 3 4 Speed Dialer To erase a stored number 3 Dialing a Stored Number 1 Storing Phone Numbers 3 To store in an UPPER memory location One-Touch Dialer To store in a LOWER memory location 3 4 To erase a stored number 2 Dialing a Stored Number One-Touch Dialer 1 2 OR From a LOWER memory location: 1 3 Memory card Special Features For Call Waiting Service Users Press (FLASH) if you hear a call-waiting tone while talking. Temporary Tone Dialing (For Rotary or Pulse Service Users) How to Use the PAUSE Button (For Analog PBX Line/Long Distance Service Users) Muting Your Conversation FLASH Button Selecting the ash time 4 PIN Code 3 4 6 7 To cancel the dial lock To set the dial lock 1 2 3 Dial Lock Call Restriction To set the call restriction 3 4 6 7 Optional Headset Optional Headset Making/Answering Calls 1 2 Battery Replacement 1 2 4 3 Troubleshooting Problem Remedy Page Important Safety Instructions SAVE THESE INSTRUCTIONS Page FCC and Other Information Page Index