„„DV mode

••Use a memory card of SD speed class 6 or above when recording with DV mode. Recording cannot be performed with a memory card of lower than SD speed class 6.

••Control space is included in the displayed capacity, and available recording capacity will be smaller than that.

••Continuous recording time is a maximum of 12 hours (when using the AC adaptor).

••The recording time of a memory card may shorten when record and delete are repeated often over and over. In that case, format the memory card with the camera. When a memory card is formatted, all data recorded on the memory card is erased and cannot be restored. Save important data to your computer.

••Partition of clips recorded on a memory card

When an SDHC memory card of 8 GB or above is used, if the recording space of a single clip exceeds

4 GB, it is automatically saved as a separate clip. Saved data can be manipulated as a single clip during thumbnail operation of the camera. When handled with nonlinear editing software or a computer, clips are handled as the separate clips.

Shooting

Removing memory cards

1Slide the <OPEN> lever of the memory card slot cover down to open the cover.

••Ensure that the memory card access lamp is not flashing orange before opening the cover.

2Press the center of the memory card, and pull the memory card straight outwards.

Memory card access lamp

••Do not remove the memory card or switch off the power at the following times, because doing so may damage the memory card.

-After inserting a memory card, while the orange memory card access lamp is still flashing until it changes to illuminated.

-While the memory card access lamp is flashing such as during shooting or during shooting finalization.

Protecting memory cards

Move the write-protect switch on the memory card to the <LOCK> position to prevent recorded content from being accidentally erased from the memory card.

LOCK

Write-protect

 

switch

32

 

15