D - MAINTENANCE AND SERVICING
CAUTIONS
•The plug must be removed from the
•To avoid injury, keep your fingers and hands away from the beater bar.
•DO NOT use hot air or hot surface to dry filters. Keep at room temperature for approximately 24 hours.
•IMPORTANT: Before
Indicator for replacing the dust bag
Turn the power control to the highest setting and lift the nozzle off the floor. If the dust indicator turns red, the dust bag is full and requires replacing the dust bag.
NOTE: If the dust bag is not properly installed, the cover will not close. Be sure to check that the bag is properly installed before operating, otherwise dust will leak out.
The dust bag can easily lay on the dust cover packing or clip between bag collar and body, so be sure to properly extend it into the vacuum cleaner body.
Replacing the dust bag
Floor nozzle
Using an old toothbrush or similar tool, clean any dirt or lint from the brush.
Turbine nozzle
Then cut across threads, strings, hairs, etc. from the beater bar with a pair of scissors. (Removal as per reverse procedure)
NOTE: Take care not to cut the brush.
Do not wash in water.
Vacuum cleaner body
Maintaining the Pre-motor Filter
Perform the procedure given below when the suction power is not restored after maintaining the filter.
NOTE: Make sure you remember to replace the filter. If the filter is not installed, it will cause motor failure.
•Do not wash the filter in a washing machine or dry it with a dryer or other source of hot air.
Filter care
D-12 Exhaust filter
Exhaust air filter,is installed in the rear side of the vacuum cleaner.
This filter retains any small dust particles which may be present in the expelled air. It is advisable to change the clean air filter when it becomes dirty. To change the clean air filter,hold the exhaust cover (as illustrated) and pull it out.
After changed the filter, set the exhaust cover to original position(as illustrated).
NOTE:
IMPORTANT: Never use the cleaner without the correct filters properly installed. Failure to do so may result in damage to the motor.
What to do if your cleaner does not work
Check that the appliance is correctly plugged in and that the electrical socket is working. In case that the thermal
If after having checked the mentioned points, the cleaner does not work, take it to an Authorised Service Centre to be repaired.
What to do when the suction performance reduces
•Stop the cleaner and unplug from the socket.
•Check whether the wans, hose and accessories are blocked or not.
If they are blocked, remove the obstruction.
•Check that the dust bag is full.
If it is full, replace it.
•Check that
If they are blocked, clean them out or replace.
SPECIFICATIONS |
| |||
|
| |||
|
| |||
|
|
| ||
Power source | ||||
|
|
|
| |
Max. Input |
| 2000 W | ||
|
|
| ||
Nominal input | ||||
|
|
|
| |
Dimensions | 280 mm x 430 mm x 260 mm | |||
(W x L x H) | ||||
|
|
| ||
|
|
|
| |
Net weight |
| 5.1 kg | ||
|
|
|
| |
Extension |
| Telescopic | ||
wand |
| |||
|
|
| ||
|
|
|
| |
Crevice nozzle | √ |
| √ | |
|
|
|
| |
Dusting brush | √ |
| √ | |
|
|
|
| |
REMINDER FOR CUSTOMER
The model and serial number of this product may be found on
the nameplate located at the underside of your cleaner. You
should note the model and serial number in the spaces
provided and retain this book as a permanent record of your
purchase.
Model Number. ......................................................................
Serial No. ...............................................................................
Date Purchased. ....................................................................
Where Purchased. .................................................................
5
