Panasonic MC-GG283 Before Requesting Service, Problem, Possible Cause, Possible Solution

BEFORE REQUESTING SERVICE

WARNING Electrical Shock or Personal Injury Hazard

Disconnect the electrical supply before servicing or cleaning the vacuum cleaner. Failure to do so could result in electrical shock or personal injury from vacuum cleaner suddenly starting.

Review this chart to find do-it-yourself solutions for minor performance problems. Any service needed, other than those described in these Operating Instructions, should be performed by an authorized service representative.

PROBLEM	POSSIBLE CAUSE		POSSIBLE SOLUTION
Vacuum cleaner	1. Unplugged at wall outlet.		1.	Plug in firmly. Push ON-OFF
will not run.				switch to ON.
	2.	ON-OFF switch not turned on.	2.	Push ON-OFF switch to ON.
	3.	Tripped circuit breaker/blown	3.	Reset circuit breaker or replace
		fuse at household service panel.		fuse.
Poor job of dirt	1. Full or clogged dust bag.		1.	Change bag.
pickup.	2.	Broken belt.	2.	Replace belt.
	3.	Carpet height selector incorrect.	3.	Set in the correct position.
	4.	Clogged hose or nozzle.	4.	Clean hose or nozzle area.
	5.	Hose not inserted fully.	5.	Insert hose.
	6.	Worn agitiator.	6.	Replace agitator.
	7.	Hole in hose.	7.	Replace hose.
	8.	Dust cover improperly installed.	8.	Properly install dust cover.
	9.	Belt not installed on motor shaft.	9.	Install belt on motor shaft.
Dust escapes	1. Bag improperly installed.		1.	Properly install bag.
the paper bag.	2.	Bag torn.	2.	Replace bag.
Vacuum cleaner	1. Wrong pile height setting.		1.	Adjust setting.
picks up
moveable rugs
or pushes too
hard.

- 40 -