MC-V414 00
3 REPLACEMENT INSTRUCTIONS
3.1. | Lower Plate | 3.3. | Agitator Assembly |
3.1.1. | Removal | 3.3.1. | Removal |
1.Place handle in low position.
2.Turn the vacuum cleaner over exposing the underside. Release the lower plate by pressing the two (2) latches that secure it inward.
3.Separate the lower plate from the vacuum.
1.The brushes are not replaceable separately. When the brushes need replacing, the agitator assembly will have to be replaced.
2.Carefully lift up on the agitator assembly until it clear both sides of the nozzle housing.
3.1.2.Installation
1.Close the rear belt cover.
3.Hook the front of the lower plate into the slots on the front of the nozzle housing. Press the lower plate down into place.
4.Fasten the lower plate by pushing the two (2) latches out- ward.
5.NOTE: For general servicing, it is necessary to eliminate pinching of any wire during reassembly. After servicing any electrical component or enclosure, the unit should be reassembled and checked for dielectric breakdown or current leakage.
3.2.Belt Replacement
3.2.1.Removal
1.Follow the removal instructions outlined in the AGITATOR ASSEMBLY REMOVAL/INSTALLATION section.
3.2.2.Installation
1.Place the new belt around the motor shaft and follow the installation instructions in the AGITATOR ASSEMBLY REMOVAL/INSTALLTION section.
3.Remove the belt from the motor shaft by sliding it off between the end of the shaft and the nozzle housing.
3.3.2.Installation
1. Place the belt around the motor shaft.
2.Place the belt around the agitator pulley on the agitator assembly.
3.Reassemble the new agitator assembly back into the noz- zle housing by placing the side opposite the belt partially into the slot. The small tabs should be aligned with the nozzle. This will hold the agitator in place and leave both hands free to place enough tension on the belt to allow that side of the agitator to return to the nozzle housing slot.
4.Rotate the agitator assembly by hand to insure nothing rubs and to check for correct assembly.
5.Replace lower plate.
10
