MQ-W
SPECIFICATIONS
1) Ratings
Operating side | Rated operating voltage | 12 to 24 V DC | |
Rated current consumption | 30 mA or less (excluding load) | ||
| |||
Load side | Output current capacity | 100 mA or less | |
|
|
|
2) Performance
Detection principle | Triple beam triangulation sensing method | ||||||
Detection method |
|
|
| Area reflective type |
| ||
Type |
|
|
| Amplifier selfcontained DC type |
| ||
|
|
|
|
|
| ||
Part number |
|
|
| ||||
|
|
| |||||
|
|
|
|
| |||
|
|
|
|
|
| ||
Sensing range |
| 0.03 m .098 ft. |
| 0.2 m .656 ft. |
| 0.7 m 2.297 ft. | |
Detectable distance | 0.02 to 0.04 m .066 to .131 ft. |
| 0.04 to 0.2 m .131 to .656 ft. |
| 0.2 to 0.7 m .656 to 2.297 ft. | ||
Standard target |
| White drawing paper |
| White drawing paper |
| White drawing paper | |
| 1 1 cm .394 .394 inch |
| 2 2 cm .787 .787 inch |
| 7.5 7.5 cm 2.953 2.953 inch | ||
|
|
|
|
| |||
Detectable target |
|
|
| Opaque, translucent |
| ||
Hysteresis |
| 10% or less the set range |
| 20% or less of the set range | |||
Operating voltage range |
| 9.6 to 30 V DC ripple |
| ||||
Response time (freq.) | 2 ms or less (250 times per second or less) | ||||||
Initial insulation resistance | Min. 20 MΩ between a lead wire and external housing (at 500 V DC) | ||||||
Initial breakdown voltage | Between a lead wire and external housing: 500 Vrms for 1 min | ||||||
Vibration resistance | 10 to 55 Hz (1 cycle/min), double amplitude 1.5 mm .059 inch (2 h each on 3 axes) | ||||||
Shock resistance |
| 980 m/s2 {approx. 100 G} (6 times each on 3 axes) | |||||
Protective construction | Diecast case immersion protected (equivalent to IEC IP67) | ||||||
Usable ambient |
| Incandescent lamp |
|
| 10,000 lux or less |
| |
light level |
| Sunlight |
|
| 30,000 lux or less |
| |
|
|
|
|
| |||
Ambient temperature | |||||||
Ambient humidity |
| Max. 85% RH | |||||
Storage temperature |
|
|
|
| |||
Indicator |
| Operation indicator: Red LED ON with light entry | |||||
| Adjustment indicator: Red LED ON with sufficient volume of lights | ||||||
|
|
| |||||
Light source |
| Infrared LED/Red LED (R is added to the suffix of W3(20)A(C) in the part No.) | |||||
|
|
|
|
|
|
|
|
Note: Unless otherwise specified, the measurement conditions comprise rated operating voltage, power supply by battery, 20°C 68°F ambient temperature, standard target and 200 lux or less illuminance on the receiver surface.
3) Output circuit diagram
NPN Output type | PNP Output type |
08/2005 | 267 |
|