Before using
10
LSQT0893
Inserting/removing a card
Before inserting/removing a card, be sure to turn
the power [OFF].
If the card is inserted or removed with the power
turned on, this camera may malfunction or the
data recorded on the card may be lost.
1Open the LCD monitor and then slide the
[2OPEN] Lever to open the card slot cover.
2Insert/remove the card into/from the card
slot.
When inserting a card, face the label side 1
towards you and push it straight in with one
stroke as far as it goes.
When removing the card, open the card slot
cover and press the centre of the card and
then pull it straight out.
3Securely close the card slot cover.
ªConcerning the card
Do not touch the terminals on the back of the
card.
Do not format the card with another movie
camera or any personal computer. This
operation may make the card unusable.
Electrical noise, static electricity, or failure of the
movie camera or the card may damage or erase
the data stored on the card. We recommend
saving important data on a personal computer
by using a USB cable, PC card adaptor, and
USB reader/writer.
ªCard access lamp
When the camera accesses the card (reading,
recording, playback, erasing, etc.), the access
lamp lights up.
If the following operations are performed when
the access lamp is lit, then the card or the
recorded data may be damaged or the camera
may malfunction.
Opening the card slot cover and inserting or
removing the card
Operating the [OFF/ON] switch or the mode
dial
ªSD Memory Card
The memory capacity indicated on the SD
Memory Card label corresponds to the total
amount of capacity to protect and manage the
copyright and the capacity available as
conventional memory for a movie camera,
personal computer or other equipment.
ªConcerning the write protection

switch on the SD Memory Card

The SD Memory Card has a write protection
switch on it. If the switch is moved to [LOCK],
you cannot write to the card, erase the data on
it, or format it. If it is moved back, you can.
1
GS35_25GN.book 10 ページ 2005年1月31日 月曜日 午後3時25分