Panasonic NV-GS35GN Setting date and time, Adjusting LCD monitor/viewfinder, About date/time

Before using

3Press the [MENU] button to exit the menu screen.

VAR.

SEARCHMENU

ENTER

Setting date and time

If the screen shows the incorrect date/time, then adjust it.

≥Set to Tape Recording Mode or Card

Recording Mode.

1Set [BASIC] >> [CLOCK SET] >> [YES].

2Move the joystick left or right in order to select the item to be set. Then move the joystick up or down to set the desired value.

≥The year will change as follows: 2000, 2001, ..., 2089, 2000, ...

≥The 24-hour clock is used.

3Press the joystick to determine the setting.

≥The clock function starts at [00] seconds.

ªAbout date/time

≥The date and time function are driven by a built- in lithium battery.

≥Make sure to check the time before recording because the built-in clock is not very accurate.

ªRecharging the built-in lithium battery

≥If [0] or [--] is indicated when the camera is turned on, then the built-in lithium battery runs down. Connect the AC adaptor to the camera or place the battery on the camera, and the built-in lithium battery will be recharged. Leave the camera as is for approx. 24 hours, and the battery will drive the date and time for approx. 6 months. (Even if the [OFF/ON] switch is set to [OFF], the battery is still being recharged.)

WARNING

THE LITHIUM BATTERY IN THIS UNIT MUST ONLY BE REPLACED BY QUALIFIED PERSONNEL. IF THIS IS NECESSARY, CONTACT THE PANASONIC CUSTOMER CARE CENTRE ON 132600 FOR YOUR NEAREST AUTHORIZED SERVICE CENTRE.

Adjusting LCD monitor/viewfinder

ªAdjusting the brightness and colour

level

1Set [SETUP] >> [LCD SET] or [EVF SET] >> [YES].

2Move the joystick up or down in order to

select the item to be adjusted. [LCD SET]

:Brightness of the LCD monitor

:Colour level of the LCD monitor [EVF SET]

EVF :Brightness of the viewfinder

3Move the joystick left or right to move the bar indication representing the brightness.

4Press the [MENU] button or the joystick to complete the settings.

≥In order to adjust the brightness of the viewfinder, close the LCD monitor, and the

viewfinder will be activated.

≥When the LCD monitor is rotated by 180° towards the lens, the brightness of the LCD monitor cannot be adjusted.

≥These settings will not affect the images actually recorded.

14

LSQT0893