Panasonic NV-RZ10EN/A Supplying Power with the Battery, Attach the Battery, Charging Lamp Charge

2 3	1	3
	1	2
		4
		4
		ENGLISH

Supplying Power with the Battery

Charge the Battery before using it.

1

≥1

≥

2

≥ xmltboz	￿ 2 ￿x`e^odbz	￿ 3￿￿
≥	x`e^odbz 3

3	N
4		!"
￿￿	￿￿
￿￿
		x2 _^qqbov
bgb`qz￿4
≥	x`^jbo^LlccLs`oz	xlccz￿

∫x`e^odbz

1 Attach the Battery.

≥Align the Battery with line 1 and push it in the direction of the arrow while holding it down.

≥When charging, do not connect the DC Input Lead to the AC Adaptor.

2 Connect the AC Mains Lead to the AC Adaptor and an AC mains socket.

≥The [POWER] Lamp 2 and the [CHARGE] Lamp 3 light and charging starts.

≥If the [CHARGE] Lamp 3 does not light even though the Battery is attached, remove the Battery and then re-attach it.

3 Remove the Battery by sliding it in the opposite direction of Step 1 above.

4 Insert the Battery with its top (so that the arrow points upward) into the top Battery Holder and press the bottom of it toward the Movie Camera until it locks with a click.

Removing the Battery from the Movie Camera

Hold the Battery firmly to prevent it from dropping and pull it off while sliding the [2BATTERY EJECT] Lever 4 in the direction of the arrow.

≥Before removing the Battery, set the [CAMERA/OFF/VCR] Switch to [OFF].

≥
	￿￿xmltboz￿￿x`e^odbz
≥	NM￿–PM￿￿
≥
≥

∫Charging Lamp [CHARGE]

Lit: During charging

Off: The Battery is fully charged.

≥When first charging a Battery that is completely discharged as a result of being in storage for an extended period of time, etc., the [POWER] Lamp and the [CHARGE] Lamp both flash.

≥Charge the Battery at a room temperature between 10oC and 30oC.

≥During recording or charging, the Battery becomes warm. However, this is normal.

≥To ensure precise indication of the remaining battery power, always use a fully charged Battery when attaching a Battery.

-20-