ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):
!Power 24VAC, Class 2 Only
52 watts at 24 VAC (Heater & Blower) Accessory Power Heater: 50 watts
Blower: 1.7 watts
13 watts Camera Power (models
BNC
(2)4 position Molex connectors (power)
(1)Phone style plug (control)
NOTE: This unit is designed for operation in an upright position. Installing the unit upside down may cause damage to the internal equipment, and will void the warranty.
GENERAL INSTRUCTIONS FOR MOUNTING HOUSING
INSTALLING PENDANT MOUNT (POD9CW/POD9CFW)
1.This unit includes a 1 1/2" NPT coupling for a standard 1 1/2" NPT pipe. The POD9 can be used with other brackets designed with 1 1/2" male pipe threads, such as the Panasonic PWM20G and PWM30G wall mount brackets.
2.Attach the housing coupling (Figure 2).
NOTE: Pipe threads should be clean and rust free. Use a sealer (such as Teflon™ tape or silicone sealer) on the threads.
Add thread sealing tape
Figure 2
INSTALLING THE HOUSING ASSEMBLY FOR WALL MOUNT POD9CW/POD9CFW
1.A wall mount bracket comes standard with this unit, and a template is included to use as a guide for mounting the bracket to a wall. Choose the desired location for installation and mark the drill holes using the template.
NOTE: Be sure the hardware and the mounting surface can sup- port the weight of the wall mount bracket plus the weight of the housing and drive unit. The load will be subjected to vibration from the camera motor and wind.
2.The wall mount bracket provided with the POD9CW includes a location for conduit entry. If you wish to install conduit to the bracket remove the conduit hole plug. Install fitting from below the wall mount and secure with conduit nut from inside the bracket.
3.Open the access door on the bottom of the wall mount by loosening the screw nearest the mounting plate (Figure 1).
1.Mount the housing assembly to the mounting bracket and housing coupling. A safety cable is included with the housing to temporarily hold it while making wiring connections. Loop the safety cable over one of the set screws on the housing coupling and make the appropriate connections using the wiring chart supplied on Page 4.
!
Make sure set screw is secure before hanging housing from screw
Figure 3
2.Upon completing wiring, undo the safety cable and twist the housing onto the housing coupling. Secure all (3) setscrews provided on the housing coupling (Figure 4).
Access panel
Figure 1
4.Attach the wires from the wall to the connector provided, using the wiring color code chart as a guide.
5.Once all wiring connections are made, place the wires inside the wall mount bracket and close the access door. Secure with the screw removed earlier.
6. Clean the outside of the dome. | - - |
|
Set screws
Figure 4
3. Clean the outside of the dome.
