Panasonic POD9CF(W), Pod9cw INSTALLATION FOR WV-CS954UNITIZED CAMERA, Add 1 Spacers

INSTALLING QUICK RELEASE BRACKET AND PAN/TILT CAMERA ASSEMBLY (ALL MODELS)

1.Open the housing by loosening the (3) screws on the dome trim ring (Figure 1). Note the arrows and the word "Locked" on the side of the housing and trim ring. Rotate the trim ring until the bottom arrow aligns with the second top arrow, then pull the dome and trim ring off.

!Make sure all (3) captive bolts drop away from trim ring before turrning!

Figure 1

2.Install the pan/tilt unit quick- release bracket. It is recom- mended that this be done before installing the housing.

INSTALLATION FOR WV-CS954 UNITIZED CAMERA

INSTALLATION FOR WV-CS574 UNITIZED CAMERA

1.Installation for WV-CS574 Unitized Camera. Add additional 1" spacers (from packet assembly) to the existing spacer already installed in housing. Connect he quick release bracket using the (4) 8x32x1/2 bolts and #8 star washers (Figure 1b).

Add 1" Spacers

Figure 1b

1.Connect the quick-release bracket to the spacers using the (4)

8 x 32 x 1/2" bolts and #8 star washers to the top of the spacers as shown (Figure 1a).

2. Attach the unitized camera to the quick-release bracket. Secure the safety screw (Figure 2). Connect the BNC, power, control, and alarm cables. Make sure all wiring is clear of the blowers and heater on the housing bracket. Use the cable tie provided to secure the wires and connectors.

Figure 1a

2.Attach the unitized camera to the quick-release bracket. Secure the safety screw (Figure 2). Connect the BNC, power, control, and alarm cables. Make sure all wiring is clear of the blowers and heater on the housing bracket. Use the cable tie

provided to secure the wires and connectors. Figure 2

- -